Rom flash tool mk8081 how to#
The LED will not light! 5) You are now in ROM flash mode.īuy from: This is a basic how to on Flashing the firmware. 4) YOu should here windows BONG it found a new device. You will feel the button 'click' when you are on it.ģ) Hold this button down and while holding it, plug the USB cable from the PC to the OTG port on the mk808. I actually enlarged the hole so a paper clip would fit. Use a paper clip or something to push the reset button in this hole. The other in the corner is a reset button under the hole. 1) Have the USB cable unplugged.Ģ) Near the HDMI port are 2 holes in each corner.
Rom flash tool mk8081 manual#
Quote: Flash mode using the reset button: If you do not ever see the flash tool say 'Found RKAndroid MASS Storage USB' Or reboot to flash mode does not work, then use this manual proceedure. If it is not pink again make sure: a) USB storage is turned ON b) Under developer options, USB debugging is turned off Once you have a pink box, Click the 'switch' button at the bottom and this should put it into flash mode. Run this tool and the 1 box should be pink. In my ROM kit is another folder called alternate_reboot_to_flash_tool This is the RKBatch tool. If reboot to flash mode does not work, then use this alternate proceedure. It will boot back up normally out of flash mode. You are now in flash mode! To get out of it at any time just unplug the USB power to the mk808. 7) If the unit does not reboot to a blank screen, repeats steps above Congrats! The unit should reboot and the screen for the mk808 will be black (no ouptut). How to upgrade your HDMI dongle MK809II to Android 4.2.2 with the.Ĥ) YOu should see at the bottom it says 'Found RKAndroid Mass Storage USB' If it does not say that go into settings and make sure that a) USB storage is turned ON b) Under developer options, USB debugging is turned off 5) Once it says 'Found RKAndroid Mass Storage Usb' in the flash tool click the 'Reboot to Flash Mode' button. Writing Images to the MK808 from Linux - posted in MK808. Further readings: How to setup SP_Flash_Tool_Linux.
Rom flash tool mk8081 install#
If you have problem with flashing tool or drivers install MediaTek USB VCOM drivers. 3) In the ROM kit run the ROM FLash Tool.exe. It will power up and windows may detect the device. 2) Connected the supplied USB cable from the device OTG port to your PC. Quote: o put the mk808 into flash mode the easy way: 1) Remove any SDcard you may have installed.
0 kommentar(er)
